Catalyst 6807-XL
Modular Switch, for the Next-generation Campus
Cisco Catalyst
6807-XL Switch, Optimize for 10 Gigabit Campus Services
Want enhance campus backbone
services? Yes, with Cisco Catalyst 6807-XL Switches.
This Catalyst 6807-XL modular
switch offers higher slot and switching capacity for the services of today and
tomorrow, and includes features and operations that are consistent with
Catalyst 6500 switches.
It supports existing Supervisor
Engine 2T, line cards, and service modules.
The Catalyst
6807-XL is ideally suited for enterprise core and aggregation environments and
offers industry-leading Gigabit Ethernet, 10 Gigabit Ethernet.
The platform is
also ready to support 40 Gigabit Ethernet.
The Cisco Catalyst 6807-XL is built on the Cisco Catalyst
6500 DNA and runs the same Cisco IOS Software operating system as the Cisco
Catalyst 6500 Series Switches. At FCS
the switch will support all the features supported on the Cisco Catalyst 6500-E
Series Switch.
At 10 rack unit,
the Cisco Catalyst 6807-XL chassis is smaller than the Cisco Catalyst 6506-E
chassis while providing an extra slot. This coupled with support for the Supervisor
Engine 6T, Supervisor Engine 2T and its family of line cards means
upgrading the campus backbone can be done with simplicity, speed, and full
investment protection.
Cisco Catalyst 6807-XL Switch
- 5 module slots, 2 SUP slots 10 RU
- Slot capacity of up to 880 Gb per slot
- Switching capacity up to 11.4 Tb/s
- Supports ASA, NAM-3, and WiSM2
Features and
Capabilities
The Cisco Catalyst 6807-XL supports the following:
● Cisco
Catalyst 6500 Series Supervisor Engine 2T (Standard and XL)
● Current
Fabric Modules (Cisco Catalyst 6700, Catalyst 6800, and Catalyst 6900 Series)
● Current
Service Modules (Cisco Catalyst Network Analysis Module 3 [NAM-3], Wireless
Services Module 2 [WiSM-2], and Adaptive Security Appliance Services Module
[ASA-SM])
● Future
Supervisor Engines
● Future
Fabric Modules
● Future
Service Modules
● Current
(e.g. 15.1SY) Cisco IOS Software release
● Future
(e.g. 16.0SY) Cisco IOS Software releases
The 6807-XL
supports the 220Gbps per slot, 2Tbps Sup 2T. In addition to the 4x100G line
card, sources expect a 12x40G module for the Catalyst 6807-XL, as well as a
48-port 10G line card.
Height 17.5” (10RU)
Width 16.318”
Depth 18.10”
1 x 9-Fan 4500
RPM High-Efficiency Fan-Tray =>100 CFM/Slot
4 x Viking
Power Supplies @ Platinum Power Efficiency = >90%
Other
Highlights:
•Supports
both traditional DBUS/RBUS Bus connectors & 48 (8 per IO slot (40) + 4
Sup-Sup (8)) x 15Ghz SerDes Fabric channels.
•Supports
both traditional Bus-based EOBC & new SGMII-based Switched EOBC (if legacy
cards present = traditional EOBC bus).
•Supports
two advanced 3.3V control logic modules, which are front-serviceable (located
to left of power supplies).
•Supports
two 62.5MHz system clocking
modules, which are rear-serviceable (located behind back-plate).
•Supports
three VTT-E voltage termination modules,
which are rear-serviceable (located behind back-plate).
More Notes:
These PSUs are
certified as Platinum Efficient, based on >90% efficiency rating.
http://en.wikipedia.org/wiki/80_Plus
Such PSUs waste
20% or less electric energy (as heat) at the specified load levels, thus
reducing electricity use and bills compared to less efficient PSUs.
These are Viking
3000W power supplies P/N: 341-0401-XX
Viking power
supplies are communicated with via I2C.
The particular
I2C is known as PMBus. This is an industry standard (see pmbus.org)
PSU Fault
conditions are:
• 5V out of range
• Output stage OT
• Fan Fault
• Or-ing fault (Output voltage
less than bus voltage)
• OC shutdown
• OT shutdown
• OV shutdown
• Input stage OT
• Fault induced shutdown occurred
• Thermal sensor fault
• Vout out of range
• Boost Vbulk fault (AC power
supply only)
Cisco
ONE Software for Access Switching is available for the Cisco Catalyst
6807-XL Modular Switch.
More Related
